Barry Wehmiller Bottle Warmer / Cooling Tunnel
Can be used also as a Cooling Tunnel as it is currently set up
Can Be Converted into a Pasteurizer Tunnel
Size: 10’ Wide x 45’ Long
New in 2005
Serial #BW-110-11-45
13” Clearance (can accommodate taller bottles)
SS Construction
Intralox Plastic Belting
SS internal overhead spray bars with nozzles
(6) SS Sections – 7’-6” Long x 10’ Wide belted area
Air Knife with Dual Blowers and auto raise / lower feature
SS Lids (removable)
6 Zones
(6) Shermco or similar 15 HP Centrifugal water pumps, nominal 3500 RPM each pump, approx. 50 GPM each
Manifold for (6) pumps included
(6) SS Filter / Strainer boxes with SS Screens
6” SS Return piping included
(1) 5 HP Centrifugal Water pump for hot water supply
Hot water supply piping, valves, etc. included
Exhaust blower with 3’ long SS Duct extension
Gauges, probes, etc. as installed
SEW 1 HP Main drive with gear reducer
SS Leg levelers with elevating 24” SS Cans
SS Electrical panel, size 6’ long x 14” Deep x 6’ high +legs
Multiple E-Stops
Cutler Hammer Power-Pro Panel Mate
PLC Controls
VFD speed controller for main drive motor
Electrical 230/460 Volt / 60 Hz / 3 Phase
Additional Pictures available upon request
Currently installed, being removed June 20th
Excellent Condition !!
Additional Prep Fees May Apply