Clausing 6913 Variable Speed Lathe
Used (Unit Powers up. Spindles Turn. Power has been disconnected.)
Model Number: 6913
Serial Number: 600815
Machine Specs:
· 14” Swing
· 48” Between Centers
· 36-1600 RPM variable speed with back gear
· L00 Spindle Taper
· 3 hp, 480 V, 3-phase
· Spindle break
· Tail stock
Ways and Lead Screw are good. Some surface rust from sitting around. No big deal.
NOTE: The belts in front are extra belts.
Special Comment about voltage:
If any customer is looking to set this up as a single phase lathe too use it at his house, there are two ways to do that.
1) Use a phase converter. You can get them on line and they are not very expensive. That would be the best way. If you do that you do not have to change anything on the machine. It is a plug in and go way to do it.
2) You can change the motor on the lathe. You will have to change the starter on it as well. You may not be able to use the reverse on the machine if you do that. This way is the wrong way to do it. It will also cost more to do it this way.
Additional Prep Fees May Apply