SPECIFICATIONS
DETAILS AND DIMENSIONS
GENERAL: The MG1532 has a 7.5 H.P. grind motor, 1H.P.mix
motor and an 8-foot length cord and plug power connection.
Casters, air-drive foot switch, drain pan and splash shield are
standard. Available voltages are 208/60/3 and 240/60/3.
ELECTRICAL CONTROLS: Electrical controls consist of front
mounted water resistant switches, magnetic contactors, dual
motor overload protection and foot switch operation capability.
An electrical interlock switch is provided. Whenever the hopper lid is opened, power to the motors is shut off. The hopper lid must be in its proper operating position before the motors can be started.
CAPACITY: The MG1532 Mixer-Grinder hopper has meat
capacity up to 150 pounds depending on the type of product.
The grinding rate is 55 to 60 pounds of fresh boneless beef per minute, first or second cutting through a 1/8" plate; 60 to 65 pounds of pork per minute second cutting through a 3/16" plate. The MG1532 is for fresh or frozen meat tempered to 24 deg. F. or higher and can be in flake or stick form.
GRINDING END: The mixer-grinder is equipped with a “Wedge
cylinder” grinding end. This grinding end is sized for #32 knives and plates (not included but optionally available).
FEEDING SYSTEM: The MG1532 is powered by two separate
drive systems. A 1 H.P. motor drives the heavy-duty steel mixing arm. The arm rotates at 23 rpm and can easily be removed from the hopper for cleaning. The conveyor screw extends the full length of the hopper and cylinder. The screw rotates at a speed of 216 rpm. By depressing the MIX/GRIND START button both the mixing arm and the screw are operated. Both mixing and grinding are stopped when the STOP switch is depressed.
CLEANING: The mixing arm, conveyor screw, cylinder, and
conveyor screw drive-shaft seal and mix arm seal are removable from the mixer-grinder for cleaning.
SPECIAL EQUIPMENT: When the MG1532 is used with a side
feed as a second cut machine, a grinding end adjusting ring is
required to attach to Hobart grinders, and special adapters are
required to attach to other makes. When ordering a side-feed
adapter for non-Hobart grinders, specify knife and plate size.
When ordering an adjusting ring for a Hobart grinder, specify
grinder model number.
FINISH: The mixer-grinder consists of glass bead finished stainless steel hopper, stainless steel panels to enclose the base assembly and motors. The mixing arm, end ring, cylinder, and conveyor screw are tinned. The casters are stainless steel and nickel-chrome plated.
Additional Prep Fees May Apply
