(2) 3" Depa Diaphragm Pumps - EPDM internal rubber diaphragms and check balls. Only moving part is air routing device in center, and it is not that hard to replace (albeit rubber parts are moving somewhat). These were used to manufacture raw cheese slurry prior to spray drying. These were not even used for a year,as an operator figured out our cream unloading pump would actually pump our thick cheese slurries.
Asking $2000 / ea. These do require a lot of compressed air to operate, but are nice in that you don't need an electrician to wire them up with 3 phase power start stop button and expensive motor starter. These will ship on standard pallet (i.e. 40"x 48"x 4"), should be easy to load and unload.
These German designed 3A pumps feature highly chemical resistant EPDM diaphragms & check balls. Because they are not electric, they may be used in very wet environments, or around explosive chemicals that need to be pumped.
(2) 2" Depa Diaphragm Pumps - EPDM internal rubber diaphragms and check balls. Only moving part is air routing device in center, and it is not that hard to replace (albeit rubber parts are moving somewhat). These were used to manufacture raw cheese slurry prior to spray drying.
We built better bottom mounting frames (easier to inspect the diaphragms) on (2) of the 2" pumps. These do require a lot of compressed air to operate, but are nice in that you don't need an electrician to wire them up with 3 phase power start stop button and expensive motor starter. These will ship on slightly overlength pallet (i.e. 40"x 72"x 4"), should be easy to load and unload.
These German designed 3A pumps feature highly chemical resistant EPDM diaphragms & check balls. Because they are not electric, they may be used in very wet environments, or around explosive chemicals that need to be pumped. (These pumps were used for several years.)
Additional Prep Fees May Apply