POWERVAR Global Power Interface 2000 Power Supply incorporates a low impedance isolation transformer, as well as a surge diverter and power line filter to eliminate noise, spikes, and transients before they have a chance to wreak havoc on your equipment. Voltage distribution and conditioning all in one solution
Standard equipment includes safety interlocks, emergency machine off (EMO), casters, and lockout/tagout breaker.
EMO, safety interlocks, lockout/tagout breaker, and casters are standard on all models
**Unit has been tested for basic functionality and has slight cosmetic blemishes from normal use
Manufacturer Specifications:
Model ABC15.0-XXD20Y
Input Voltage 208/240/480/600 delta connection (4 wire)
Output Voltage 208/120 wye (5 wire)
Frequency 60 Hz. only
Continuous Capacity 15 kVA
BTU/Hr. Output 1536
Efficiency > 97% (at full load, unity power factor)
Step Load Change + 0.8% (at unity power factor)
Noise Rejection With unit under power and the isolation transformer configured for a transformation ratio of 1:1 and with an ANSI/IEEE C62.41, Category A pulse applied either normal mode or common mode at the input, the noise output voltage will be less than 10 volts normal mode and less than .5 volts ( of one volt) common mode in all four quadrants (CM-NM, NM-NM, CM-CM, NM-CM).
Surge Voltage Withstand Tested under power to ANSI/IEEE C62.41, Category A & B (formerly IEEE587-1980).
Power conditioner tested to withstand up to 6000 volts @ 3000 amp ringwave and unipolar impulse.
Construction Materials Transformer wires are copper and insulated with Class H materials. Windings are insulated with Nomex paper insulation before vacuum varnishing. Internal wiring is a minimum of 200 degree C rated and sleeved with Class H materials. Grain oriented silicon iron cores are constructed using 14 mil. laminations interleaved one to one. Eddy currents are minimized and external magnetic fields are below 0.1 oersted (at 12 inches distance in any direction). Unit is RoHS compliant.
Additional Prep Fees May Apply
