Powervar 2000 GPI Global Power Interface ABC15.0-20D40Y
The GPI Series 2000 is designed to eliminate high-frequency noise and high-voltage impulses (also known as spikes or surges) from the AC power that runs your electronic equipment.
The power conditioner installs between the power source and the critical load, and because it is a three-phase device, the GPI Series 2000 provides protection for all transformer phases that power a large system.
Sophisticated electronic systems contribute to the profitability of your business, and clean power is an essential element in their reliable operation.
Each electronic system responds to power-quality problems differently, but properly protected systems benefit in a variety of ways. These benefits include fewer hardware failures, fewer no problem found service calls, less system downtime, higher manufacturing yield, better image quality and longer equipment life.
**Unit has been tested for basic functionality. It does NOT come with a power cord.
General Specifications:
Input Voltage: 208/240/480/600 delta connection (4 wire)
Output Voltage: 208/120 wye (5 wire)
Continuous Capacity: 15 kVA
BTU/Hr. Output: 1536
Efficiency: > 97% (at full load, unity power factor)
Step Load Change: + 0.8% (at unity power factor)
Noise Rejection: With unit under power and the isolation transformer configured for a transformation ratio of 1:1 and with an ANSI/IEEE C62.41, Category A pulse applied either normal mode or common mode at the input, the noise output voltage will be less than 10 volts normal mode and less than .5 volts ( of one volt) common mode in all four quadrants (CM-NM, NM-NM, CM-CM, NM-CM).
Surge Voltage Withstand: Tested under power to ANSI/IEEE C62.41, Category A & B (formerly IEEE587-1980).
Power conditioner: tested to withstand up to 6000 volts @ 3000 amp ringwave and unipolar impulse.
Construction Materials: Transformer wires are copper and insulated with Class H materials. Windings are insulated with Nomex paper insulation before vacuum varnishing. Internal wiring is a minimum of 200 degree C rated and sleeved with Class H materials. Grain oriented silicon iron cores are constructed using 14 mil. laminations interleaved one to one. Eddy currents are minimized and external magnetic fields are below 0.1 oersted (at 12 inches distance in any direction). Unit is RoHS compliant.
Additional Prep Fees May Apply
