Browse our other Saws and Shears
Features:• Serial #016 0004• Manufactured 07/28/2000• Maximum Cut Length: 213.5” • Minimum Cut Length: 25.5”• 5” H x 6.25” W cut capacity• 400MM (16 ½”) Saw Blades• 30mm Arbor• 480 Volt 3 Phase 60 Hz 9.3 Amps• 2 @ 2.64 kW (3.5 HP) motors• Fixed left head• Moveable right head with powered movement• Manual fine tune positioning of right head• Manual Length position lock• Constant zero point• Electronic digital length readout (0.001”)• Imperial lineal scale• Manual Miter +/-45° both heads• Electronic angle digital readout both heads (0.01°)• Indexing stops• Infinite angle manual lock• Manual compound miter, 45° out • Pneumatic saw head movement• Hydro-check pneumatic control of each head for smooth, controlled cut• Swing arm mounted controls• Two hand, maintain contact, anti-tie down actuation of saw heads• E-Stop button on control panel• Individual motor start controls• Each head equipped with left and right vertical and horizontal pneumatic hold down clamps• Independent operation of saw heads• Low air pressure safety switch• Air filter/regulator/lubricator• Minimum and maximum overtravel stop switches• Each saw head has a 3 ½” OD chip/dust port• Two center material work supports• Leveling feetCondition:• Very good condition• Completely cleaned and checked• Pneumatic lines replaced as needed• Pneumatic pilot check valves replaced as needed• Pneumatic manifold blocks installed• Saw bed inserts replaced• Horizontal clamp pads replaced• Control voltage hardwired and control box refurbished• Electrical conduit replaced as needed• Existing sawblades included• Current replacement cost, over $44,000Click Here to View YouTube VideoAdditional Prep Fees May Apply