Browse our other Homogenizing Mixers
NEXT Advance Bullet Blender Homogenizer model: BBX24**This unit has been tested to specifications. Has slight cosmetic blemishes from normal use. See photos for further details.The Bullet Blender Homogenizer enables you to homogenize, disrupt, or lyse 24 tissue or cell culture samples at a time. Load the samples int polypropylene microcentrifuge tubes, then place them in the Bullet Blender. The bullets in the blender vigorously strike all the sample tubes simultaneously for a few minutes. The Bullet Blender is available with Air Cooling to preserve your sample quality.Consistent and High Yield Results:The BULLET BLENDER homogenizer prepares up to 24 samples in just minutes. All of the samples are automatically homogenized in the same manner, with high yields, so there is very little variation from sample to sample. See the Protocols pages for preparation times and speeds.No Cross-Contamination or Sample Loss:There are no probes or blades to cause cross contamination or sample loss, which also means there are no parts to clean between runs. The sample tubes are kept closed and self-contained during homogenization.Samples Stay COOL:No cool down required. The Bullet Blender homogenizers use very little power due to the unique, patented design. There is very little heating of the samples because the sample tubes vibrate vigorously in air, keeping them cool, rather than being subjected to frictional heating as the tubes rub against the walls of a holder. Also, because the motor does not need to agitate any heavy platforms or plates, it is small and will last for many years.So Easy To Use:Simply place your sample, beads and buffer in standard tubes, and load the tubes into the BULLET BLENDER homogenizer. Tune the extent of disruption by adjusting the run time and speed. Afterwards, place the sample tubes in a centrifuge to separate the lysate. No special holders are needed. There are no clamp plates nor locking rings to fiddle with.Additional Prep Fees May Apply
