The Powerpal 3100 is a powerful, compact, electric pusher/puller powered
by 1 HP motor. It is battery operated and capable of generating 759 inch
pounds of torque allowing it to easily push / pull well over 3000 kg.
The Powerpal 3100 can operate continuously for 10 hours on a single
charge. This unit has nonmarking wheels and was operating in the pharmaceutical industry and is in very clean condition.
BENEFITS
The Powerpal 3100 increases productivity and decreases injuries
involved in transporting wheeled loads around commercial and industrial
workplaces.
By mechanizing the process of transporting loads on wheels, a single
employee can safely and efficiently transport substantially larger
loads.
The automatic brake engages whenever the machine is not in use,
ensuring safe operation on slopes. Your speed is controlled by how much
you decide to twist the throttle in forward or reverse. The nonmarking
tires coupled with an efficient motor generates low decibels and the
operator needs no protective hearing gear. An automatic reverse button
is located on the tiller to increase safety.
MATERIALS
Drive fully shielded from environmental hazards by steel lower frame.
MOTOR
System drive:
Integral Stature motor drive and axle assembly: 30.87:1 motor to axle shaft ratio.
1.1 HP continuous load
Full differential wheel drive system.
BATTERIES
Operating voltage:
The Battery have been check and seem to work perfectly however no warranty is given.
36-volts D.C.: three 12-volt batteries, Trojan SCS225, 225 minute reserve capacity.
Battery level charge indicator: 10%-100% (with LED's).
Motor has capacity to draw up to 35 amps to increase peak operating conditions.
Operates up to 10-12 hours on a charge.
Recharge rate averages 8 hours from full discharge
On board 16 amp multistage self regulating battery charger
Very low threshold for automatic shut off
Charger self diagnostic lights
BRAKES
Electronic, reverse motor current braking upon release of throttle.
Automatic parking brake with power off condition or emergency stop condition.
Manual parking brake release lever.
Dynamic braking
Regenerative braking is primarily used to stop the Powerpal.
This means the energy recovered when stopping is added to the battery.
CONTROLS
Manual operation:
Speed forward: 3.2 mph maximum.
Speed in reverse: 1.6mph maximum.
Handgrip variable speed throttle control.
Integral throttle guard.
Handle spring balanced for automatic adjustable operation heights.
SAFETY FEATURES
Automatic low battery warning.
Automatic overload shutdown.
Emergency overload current limiting.
Emergency reverse button.
Programmed acceleration and deceleration for operation control.
Constant feedback control of forward and reverse speeds.
Automatic parking brake.
Tyres underneath frame for pedestrian safety.
Warning horn in manual.
Vehicle motion buzzer with adjustable volume (quiet) plus on/off switch.
Hi-Lo speed switch to reduce speed for maneuvering.
Optional strobe light.
UL Certified to UL Standard 583 and CE
Weight - 560lbs; Size - (L) 38.5", (W) 29.4",
(H) 23", 4.4" ground clearance
Many other uses for this GREAT Unit:
Can be set up to pull larger machines around or equipment in your
facility!
The unit sells for $4800 new.
PLEASE NOTE:
The
unit will be loaded on to your truck free of charge. The unit can be
skidded, strapped
Additional Prep Fees May Apply
