BIO-RAD RPN03057 Thermal Cycler for Sale

The MJ Research PTC-200 Thermal Cycler utilizes interchangeable sample blocks and heat pump assemblies, which allow the user to change format easily between runs while retaining NIST-traceable accuracy. This PTC-200 comes with a 96-well block and can accommodate60 well blocks,384 well blocks, dual 48 well blocks, and many others, including specialty blocks like the insitu. The precise Peltier effect heat pumps deliver the full temperature range of 0 to 100C electronically, all in a compact, small-footprint instrument. The MJ Research PTC-200 offers speedy ramping rates of up to 3.0/sec in models that hold 0.2ml tubes or V-well plates. It also features unparalleled temperature homogeneity of0.4C within 30 seconds of arrival at 60C for all standard models. The PTC-200 has a large memory and amiable software that allows control over virtually every thermal parameter.

Manufacture Specifications

Thermal range: 5 to 105C, but no more than 30C below ambient temperature (4 to 100C for the Slide Chambers Alpha unit)
Thermal accuracy: 0.3C of programmed target at 90C, NIST-traceable
Thermal uniformity: 0.4C well-to-well within 30 seconds of arrival at 90C
(for most Alpha units; see specifications for individual Alpha units)
Ramping speed: Up to 3C/sec for all single- and dual-block Alpha units;
up to 1.2C/sec for the Slide Chambers Alpha unit.
Sample capacity: Varies with installed Alpha unit
Line voltage: DNA Engine cycler: 100240 VAC rms (no adjustment needed among voltages within these ranges)
Frequency: 5060 Hz single phase
Power: DNA Engine cycler: 850 W maximum
Fuses: Two 6.3 A, 250 V, 5 x 20 mm
Displays: One 20 x 4 LCD alphanumeric display
Ports: One 25-pin 8-bit parallel interface printer port
One 9-pin RS-232 serial port for printer or remote use
One IEEE-488 bidirectional general purpose interface bus
Memory: 400 typical programs in up to 12 individual folders

Additional Prep Fees May Apply