Browse our other Lab Equipment
Fisher Scientific Isotemp 625D Incubator** Unit has been tested for basic functionality. unit has some minor cosmetic damages to the exterior... See photos for detailsAll models provide PID microprocessor control at operating temperatures ranging from 30 (86F) to 75C (167F).Note: Ambient temperature must be at least 5C below operating temperatures.In these models, fresh air enters through an air intake on the bottom of the incubator, then is heated in a plenum below the chamber, finally flowing into the oven chamber itself in uniform flow patterns. Exhaust air is vented through a port at the top of the incubator. Temperature readouts and control parameters are shown on red LED's. Three additional LED's indicate when the heater power is being applied, an error condition is encountered, or the temperature is being set. The Model 625D accommodates a maximum of three shelves. The Model 637D holds six shelves, and the model 650D holds 10 shelves. Isotemp Incubators incorporate a variety of safety features. A safety backup is built into the controller software. If the primary heater control fails, the backup will maintain control at 3C above the set point. An alarm LED then indicates that the backup controller is operating the incubator. A circuit breaker protects the incubator from power surges.Additional Prep Fees May Apply
