REPLIGEN C24U c3.0 ATF Xcell System Controller for Sale

Repligen XCell C24U v3.0 ATF System Controller

***ATF system controller is preowned with minimal wear from normal use. C24U powers on without errors. Buyer can expect the same item pictured with 30-day warranty. See photos for details.

(Please be advised that any warranty/guarantee/return policy provided from the seller is between the buyer and the seller only. Bid on Equipment is not and cannot be held responsible in any way. Please reference our Terms and Conditions for further information.)

XCell ATF provides an efficient filtration technology for fractionating a mixture or suspension of cells, molecules or other particulates. The filtration device includes a filtration assembly that can accept either a hollow fiber module (HFM) or a screen module (SM) for fractionation of larger particles. The filter housing is positioned between a process vessel or a bioreactor at one end and a diaphragm pump at the other end. The process vessel serves as a container for the content to be filtered. The diaphragm pump provides the means for generating alternating tangential flow (ATF), back and forth, between the vessel and pump, through the hollow fibers or screen module. During this process, a rapid, low shear, tangential flow is generated. A filtrate/harvest pump is used for controlled removal of a filtered stream. Only a single connection is required between the XCell ATF Device and the vessel. The XCell ATF Device can be connected to most process vessels, single use bioreactor (SUB) &a steam in place (SIP) connection.

Features of the XCell C24 Controller (v3)
Intended for benchtop-use
Control of XCell ATF Device flow rates in both pressure and exhaust cycles
Monitoring capabilities for air flow rate and cycle time
Set-up and selection of operation parameters
Display of real-time process data
Ethernet capabilities for remote monitoring and data logging
Alarm for error conditions
Information on algorithm performance
Simple recipes
Two-point calibration for pressure
Manual mode of operation
Power failure restart option
Ability to have software or firmware upgrades in the field by replacing memory modules
Ability to operate an XCell ATF 2 Device or XCell ATF 4 Device with standard control parameters or any variations thereof with the same hardware and software.
Programmed to also support XCell ATF 2 and XCell ATF 4 Microcarrier Devices

The XCell C24 Controller (v3) consists of the controller, a connection for compressed air supply, a connection for exhaust/vacuum service, a connecting air line between the controller and XCell ATF
Device diaphragm pump, and a 0.2 micron hydrophobic filter (F1) on the air line between the controller and ATF diaphragm pump (to ensure a physical barrier to prevent the back flow of liquid in case of diaphragm failure). The XCell C24 Controller (v3) will regulate the airflow rate and direction to establish the pressure and exhaust cycles of the XCell ATF Device diaphragm pump.

Additional Prep Fees May Apply