The Luminex Labscan 100 system enables you to multiplex (simultaneously measure) up to 100 analytes in a single microplate well, using very small samples. The system delivers fast and cost-effective bioassay results on many assay formats including nucleic acid assays, receptor-ligand assays, immunoassays, and enzymatic assays.
Manufactures Specifications
Operating Environment
Power: autosensing 100 -240 VAC, 47 - 63 Hz
Operating temperature: 15 - 30 C, 20% - 80% relative humidity non-condensing
Sensitivity
Detect 1000 fluorochromes phycoerythrin (PE) per xMAP microsphere
Reporter channel dynamic range: 3.5 decades of detection
Optics
Reporter laser: 532 nm, nominal output 10-15 mW, maximum 500 mW, frequency doubled diode; mode of operation, continuous wave (CW).
Classification laser: 635 nm, 9.1 6%,maximum output 25 mW, diode; mode of operation, continuous wave (CW)
Reporter detector: Photomultiplier tube,detection bandwidth of 565 585 nm
Classification detector and doublet discriminator: Avalanche photo diodes with temperature compensation
Fluidics
Sample volume is 20 - 200 via sample loop
Sheath flow rate: 90 L 5 L/second
Sample Injection rate: 1 L/second
Cuvette: 200 microns square flow channel
External sheath/waste containers hold enough volume to run up to two 96-well plates between refills
Additional Prep Fees May Apply
