THERMO QUEST SRVYR-AS Surveyor Autosampler for Sale

The Thermo Finnigan Surveyor Autosampler Plus is specifically designed to maximize throughput, the Finnigan Surveyor Autosampler has a novel sampling arm design minimizing excess movement, maximizing the number of injections in a given time. Injection cycles less than 30 seconds can be achieved using the Finnigan Surveyor Autosampler. The Autosampler holds 200 standard 1.8 mL sample vials or a tray insert with three 96 or 384 well microtiter plates. The built-in syringe flush and needle wash minimize carryover. The Finnigan Surveyor Autosampler heat exchanger equilibrates the mobile phase prior to sample introduction.

Manufacturer Specification
- Vial Capacity: 200 vials with tray temperature control, Three 96 or 384-Well Microtiter Plates

- Injection Precision: 1.0% RSD at 5 uL and higher

- Minimum Sample Volume: 1 uL can be injected from a 5 uL sample

- Injection Volume: 20 uL loop standard, up to 1000 uL injections with larger loops and syringe

- Sample Carryover: 0.1%, 6 mL flush can be used for internal and external needle wash

- Needle Height: Programmable in 0.1 mm increments.Active vial bottom search selectable on/off

- Column Oven: 5C to 95C +/- 0.5C selectable in 1C increments.

- Tray Temperature Control: 0C to 60C +/- 0.5C selectable in 1C increments

- Communications:
- Remote Inputs: Pump Ready and Inject Hold

- Remote Outputs: Pump Stop, Autosampler Plus Ready, Inject, and Gradient Start, 4 Timed Events

- Remote Controls: Ethernet interface for PC-based software control.

- Sample Preparation: Capacity for 4, 15 mL reagent vials for flushing, washing, sample dilution, and/or reagents for sample derivatization

- Ambient Environment: 10C to 40C, 5 to 95% relative humidity, non condensing

- Operating Temperature: 10 C to 40 C

Additional Prep Fees May Apply