The machine is a Peddinghaus TDK 1000/3G that we have had since new in 1989. In 2003 we bought a new BDL and this TDK was sent back to Peddinghaus and was refurbished. Since 2003 we have only ran the machine a few time when our BDL went down and, there were a few bugs on the TDK that needed to be straighten out, mostly dialing in the parameters but the mechanics, controllers, and accessories are all functional . We just bought another new BDL and are moving the TDK out to make room. The TDK also has an updated Fagor controller and we have thousands of dollars of new spare parts to go with it and all the paperwork for it and from the refurbishing. We have the ability to load this machine on to a shipping trailer TDK is approximately 16,000lbs, rough shipping dimensions are 7’ wide, 18’ long and 9’ tall. The TDK comes with the its Fagor controller, Hydraulic pump, air tank, 2 extra servo motors, 1 extra hydraulic motor, and a spare gear reducer, and all the drawings and schematics. and we were looking to get 10k-12k for the machine, but we are open to offers. Additional Prep Fees May Apply