Lot of Branson Plasma Etcher, controllers and Generators PM-119 and 2000C Controllers
Condition: The Branson IPC Plasmas Etchers, Controllers and Generators, appears to be in fair cosmetic condition, with few small dings, scratches and, signs of previous use. We do not have the equipment or training to formally test this item so it is being sold as is.
The information here was taken off the internet. It is up to the buyer to verify if information is correct
The Branson IPC is a barrel plasma etcher that uses oxygen to etch organic films and residues such as photoresist in a process commonly referred to as 'de-scumming.' During a normal run for the Branson Barrel Etcher, the chamber is evacuated to under 0.5 torr pressure. A regulated flow of oxygen gas is introduced into the chamber and RF energy is applied to the chamber coils, which creates an oxygen plasma which does the etching. The oxygen ions in the plasma react with organics, such as photoresist, oxidizing or descumming the compounds off of the surface. The oxidized organics are pumped out of the Branson Barrel Etcherfts chamber as exhaust gas.
The Pallet comes with the following:
One Branson IPC S2005T-11020 Plasma Etcher PM-702A (Diameter is 12in and the Depth is 22in )
Serial No. MM906730-1
One Branson IPC S3003/3 (Diameter is 8.5in and the Depth is 13in)
Serial No. M912580
Branson 2000C Gas Controller
Serial No. 10002259
P/N 07690-C
Branson 3000 2 Gas Controller
Serial No. 10010372
P/N 04643-01
Branson RF Generator
P/N 03100-02
Serial No. 10010440
Branson RF Generator
Serial No. 10000235
Additional Prep Fees May Apply