Specifications
1.Vacuum suction
2.Makes the material completely mixed
3.Control cabinet
4.Small-scale produce
5.corrosion resistant
This unit consists of vacuum emulsifying pot, heating and temperature control system, mixing system, vacuum system, electrical/hydraulic lifting system, operation control cabinet and piping system .
Parameters of Emulsifying Pot
Capacity
Design Volume:10L maximum working volume:8L
minimum working volume:3L
Pot
Structure
Materials of Inner Layer: SUS304 thickness:4mm
Materials of Middle Layer: SUS304 thickness:4mm
Materials of Outer Layer:SUS304 thickness:3mm
Configuration
On the bottom , it has a discharging valve for materiels out,
electrical heating system and temperature sensor (measuring range 0~199°C)
On the top, it has a liquid (solid particles) materiels feeding inlet, compressed air
inlet, one observation hole with light, vacuum port, pressure gauge (-1~0.5bar),
man-hole
Mixing
type
Dispersion
Installation position: under the cover of pot. Materials:SUS316L
Power:1.1kw; speed: 2800r/min
Finally particles sizes:200nm~2um
Frame Mixing and
Central Shaft mixing
Materials:SUS316L,Materials of scraper blade:PTFE
Power:0.75kw; Speed: 0~86r/min(can be adjustable by frequency converter). Frame
mixing and central shaft mixing use the same motor
Remarks:1, to start the mixer, the cover can not be raised 2, when lifting the cover
on, mixer can not operate 3, when the cover rose on the top, you can jog mixing (for
easy cleaning)
vacuum system
Water cycle type vacuum pump,Power:0.75kw
hydraulic lifting system
(for cover)
hydraulic lifting. Power:0.1kw
Heating type
electric heating. Power: 2kw
Discharging method
Dumping up cylinder or discharging valve on the bottom of the pot
Pressure
Limiting vacuum: -0.090MPa Working pressure in the interlayer and pot:0.2MPa
Operation control cabinet
Push-button switch, homogenizing time meter, temperature instrumentation( emulsifying pot, water pot and oil pot), variable-frequence governor, emergency stopping button.
Total weight
Outside sizes
800×550×1430mm
Parameters of Solveny Pot
Name
Solveny Pot
Capacity
Design volume:7.5L
Working volume:6L
Mixing type
Central Shaft Mixing
Power:0.025kw
Speed:1200r/min
Opening type of cover
Movable cover (semi-opentype)
Temperature display
digital time display
Discharging method
Discharging valve on the bottom of the pot
Heating type
electric heating. Power: 1kw
Pressure
Working pressure in the interlayer:0.2MPa
Structure
Materials of Inner Layer:SUS304 thickness:4mm
Materials of Middle Layer: SUS304 thickness:4mm
Materials of Outer Layer:SUS304 thickness:3mm
Control system
Controlling on the operation control cabinet with the emulsifying pot
Operating platform
On the same platform, the discharge valve is about 0.5m from the ground.
Parameters of Solid Container
Name
Solid Container
Capacity
Design volume:5L
Container volume:4L
Additional Prep Fees May Apply
