Twin 9in x 34in screw feeders, stainless steel: motor specifications; 15 hp, 1700 rpm, 230/460 volt, 4.7/2.4 amps, 60 hz, 1.00 s.F. Continuous duty. Speed reduction unit input speed 1700 rpm, output speed 45 RPM at 1.5 HP maximum. Overall dimensions of screw section are 72in L x 50in W x 20in high without inlet transition. Twin 9in x 34in screws runing in opposite direction. 3/8in x 2 3/4in distribution fingers on end of each screw shaft at outlets. Stainless steel shaft diameter is 2in. Material construction of unit is stainless steel. Shafts are running in external pillow block bearings with grease fittings. Stainless steel inlet transition is 57.5in overall height with six 1in level probe fittings on angular side, one 1.5in inlet or level probe ports in three sides and between large inlets on top. Inlet transition has a 20in x 20in inspection door on one side and a 22in x 7in c channel mounting frame for vibration units. Top dimensions are 32in x 36in. Unit has two 8in i.D. Inlet ports and one 3 3/4in inlet/inspection/level probe port on top. There are four 3in x 4in mounting lugs with 3/4in center hole. Outlet is completely open modified z configuration and bolts to the top of the screw conveyor system.
Additional Prep Fees May Apply.